rack-handlers
by Lin Jen-Shin (godfat)
LINKS:
DESCRIPTION:
Unicorn family Rack handlers for you. Mostly for rails s
.
REQUIREMENTS:
- Rack
- The web server you want to use (e.g. unicorn, yahns, rainbows, zbatery, etc)
INSTALLATION:
gem install rack-handlers
SYNOPSIS:
Put 'rack-handlers'
and your favorite unicorns into Gemfile
then you could do the followings:
rails s unicorn
rails s yahns
rails s rainbows
rails s zbatery
Because requiring 'rack-handlers'
would make Rack::Handler.default
pick the server with the following order:
- yahns
- zbatery
- rainbows
- unicorn
- torquebox (for jruby)
- trinidad (for jruby)
- puma
- thin
- webrick
Thus if you have rainbows installed, rails s
would launch the server with
rainbows instead of webrick (the original behaviour).
Additionally, it would also try to load the config via config/yahns.rb
,
or config/unicorn.rb
depending on which server is picked.
For people who likes to run rails s
!
CONTRIBUTORS:
- Lin Jen-Shin (@godfat)
LICENSE:
Apache License 2.0
Copyright (c) 2012-2016, Lin Jen-Shin (godfat)
Licensed under the Apache License, Version 2.0 (the "License"); you may not use this file except in compliance with the License. You may obtain a copy of the License at
http://www.apache.org/licenses/LICENSE-2.0
Unless required by applicable law or agreed to in writing, software distributed under the License is distributed on an "AS IS" BASIS, WITHOUT WARRANTIES OR CONDITIONS OF ANY KIND, either express or implied. See the License for the specific language governing permissions and limitations under the License.